LotusElan.net Unified Search
Search results for: diff bearing heat in category "Drive Train / Gearbox / Final Drive"
58 results found containing all search terms.
3 pages of results.
Sorted by relevance / Sort by date
1. Diff Input Shaft Bearing Replacement : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I need to replace my diff input shaft bearing, can this be done with the diff in situ? Thanks for any advice.
... Diff Input Shaft Bearing Replacement I need to replace ... diff input shaft bearing, can this be done with ... , you may have to heat up the diff casing ...
2. best way to get prop bolts undone.. : Drive Train / Gearbox / Final Drive - Page 2 by LotusElan.net [Drive Train / Gearbox / Final Drive]
You do not need heat to separate the 2 flanges. Just tap harder on one flange or use a sharp cold chisel and bolster in ...
... has come loose. Later diffs were an improved design ... problem is that the pinion bearings have lost their preload ... undone. You do not need heat to separate the 2 ...
3. Diff Output Shafts - What Slide Hammer? : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I've been attempting to remove the drive shafts (with anti-flail pins) from a spare diff I've gotten hold of - without success to date. I've ...
... Diff Output Shafts - What Slide Hammer? I've ... date. I've soaked the bearings (over a period ... Wrench' and I've applied heat using a heat gun ...
4. Diff. removal and jackstand placement -Snapped output shaft : Drive Train / Gearbox / Final Drive - Page 3 by LotusElan.net [Drive Train / Gearbox / Final Drive]
Quick stop in today , removed circlip and the stub axle is stuck in there good. Service manual says tap it out ...hmmmmm I carefully ...
... Diff. removal and jackstand placement -Snapped output shaft ... on tossing the circlip and bearing .. as of right ... search for "diff bearing heat": http: ...
5. DIFF SEAL REPLACEMENT : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Hello dear friends, as my Elan+2 is now completely in pieces, everything is now easily accessible. Even the diff ! It is black of grease ...
... DIFF SEAL REPLACEMENT Hello dear friends, as my ... want to fit the new bearings swith some bearing fit ... there is any hint of slackness as you don't want ...
6. CV joint removal : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Apparently this CV driveshaft has been on the car for a long time. In removing it to replace a torn boot, the inner cv came ...
... the bearing circlip in the diff case. Greg Z ... cv came apart, ball bearings everywhere.. I can't ... slide hammer, with some heat on the part that ...
7. trick for sticky diff outputshaft ?? : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
I have a stuborn diff out put shaft - normally I tap them out per the manuel , gently, ... On this particular dif I ...
... trick for sticky diff outputshaft ?? I have ... heated the area where the bearings were until alloy housing ... hot, hot, hot and then tried a slide ...
8. 2821E Gearbox Question : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Picked up a 2821E gearbox on Craigslist for $30 - the Cortina/Seven type with the external remote. When I stripped it I found that the ...
... can do everything for English diff and 2000E box except ... found that the main input bearing had failed and one ... could this have compromised the heat treatment of the layshaft ...
9. CV joint removal : Drive Train / Gearbox / Final Drive - Page 2 by LotusElan.net [Drive Train / Gearbox / Final Drive]
If the Cv joint has been assembled into the spigot on the diff output shaft with loctite depending on the grade used it may take ...
... into the spigot on the diff output shaft with loctite ... and ruin the seals and bearings. Pulling the diff ... shaft requires removing the circlip in the alloy housing gripping ...
10. Bang/clonk noise, followed by no drive : Drive Train / Gearbox / Final Drive - Page 2 by LotusElan.net [Drive Train / Gearbox / Final Drive]
The early diff shafts break with both Donuts or CVs. By now even in gently driven cars they need replacing cheers Rohan
... by no drive The early diff shafts break with both ... puller to help ease the bearing out (once the ... axles, I used a heat gun to warm the ...
11. S3/SE diff cooling duct : Drive Train / Gearbox / Final Drive - Page 2 by LotusElan.net [Drive Train / Gearbox / Final Drive]
so this is just a less visible (but more likely to get broken off) version of the side scoop/ducting? so this is just a less ...
... S3/SE diff cooling duct gordont wrote: ... diffs apart and both had bearing problems. The bearing ... due to low lube or heat I'm not sure, ...
12. Pinion oil seal : Drive Train / Gearbox / Final Drive - Page 5 by LotusElan.net [Drive Train / Gearbox / Final Drive]
Well done Jon and i think i would do the same and leave the output shafts alone. Don't take any risks Alan
... decide later to remove the Diff Output Shafts you can ... it. I expect the bearings have been loctited in ... hand you'll have to apply heat pretty forcefully to destroy ...
13. Rear Strut - Axle Shaft & Bearing Removal. : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Over three decades of elan ownership, you become a little wiser about the various lotus quirks, and develop a better understanding of these great little ...
... is also very useful for diff out put shafts. ... Strut - Axle Shaft & Bearing Removal. Over three ... fitted shaft. Apply some heat to the ally case ...
14. Removing diff output shaft bearings : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Salut Along with Leslie's lovely looking diff, I managed to find a good diff case and late output drive shafts for not much money (always ...
... Removing diff output shaft bearings Salut Along with Leslie's ... looking diff, I managed to find a good diff ... to use a bit of heat on the diff casing ...
15. Diff Restoration : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
The diff is working ok but would like to restore the appearance so best to remove input and output shafts and while at it bearings ...
... Diff Restoration The diff is working ok but would ... shafts and while at it bearings and seals. Dont ... sure whether or not using heat is a good idea ...
16. Input Differential Oil seal : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Hi everyone, I have just noticed that my rear input diff oil seal has developed an oil leak ? What a pain. Has anyone replaced ...
... noticed that my rear input diff oil seal has developed ... fretting wear or the pinion bearings are loose or both ... would appear that time, heat and oil had taken ...
17. Diff output shafts? : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Hi all. Does anyone have any tricks for removing the Output Shafts? Made a bit of a Blunder to put it mildly, put the chassis ...
... Diff output shafts? Hi all. Does anyone ... the inner race of the bearing. That might not ... your hope for "in situ" examination. Current ...
18. Diff output shaft question : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Having just had another rotoflex failure I have been reading the thread on which cv conversion to go for. A few years ago I changed ...
... Diff output shaft question Having just had another rotoflex ... a circlip that retains the bearing outer race in the ... be relieved by applying gentle heat to the housing to ...
19. Diff Drip : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Ive got a very small leak starting from my input shaft (propshaft) into the diff....... Im going to keep an eye on it....but anything I ...
... Diff Drip Ive got a very small leak starting ... Rumble is possibly output shaft bearing or wheel bearing wear ... . at motorway speeds This heat will pressurize the ' ...
20. Any specific type of slide hammer for output shaft removal : Drive Train / Gearbox / Final Drive by LotusElan.net [Drive Train / Gearbox / Final Drive]
Good news - this is the last major thing to do before the engine etc goes in (I know not in the way, just want ...
... to 20 minutes for the diff to drop smoothly. ... warm the housing around the bearing prior to removal, ... tdskip If you take a heat gun and warm the ...
Search took 0.172 seconds