Lotus Elan

LotusElan.net Unified Search

Search results for: diff bearing heat in category "Classifieds"

31 results found containing all search terms.

2 pages of results.
Sorted by relevance / Sort by date
Thanks for all the replies. The holes in the outer tube are near the bottom. Someone used set screws that were too long in a ...
... seal kit for the rear diff and hub shafts. ... the outer tube from aluminum bearing assembly and replace with ... to the bearing assembly to heat it up and hope ...
Terms matched: 3  -  Score: 1976  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=34204&start=15
I would be grateful for some advice: my Lotus is an Elan +2 with standard rear suspension. I noticed when I last drove off a ...
... big money spending. The diff. is leaking, ... between the perch plate and bearing carrier is the same ... feel but no noise or heat notice earlier) in ...
Terms matched: 3  -  Score: 1850  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=22123
If the shaft was too far out the bigger gap would be on the outside of the caliper. Therefore if it needs shims, the gap ...
... housings, ie hubs and diff casing, is heat ... into it but the original bearings are not sealed they ... and diff casing, is heat, and a lot ...
Terms matched: 3  -  Score: 1692  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=46410&start=30
Yes. IMG_4445.jpg On the right, the old shaft with inside bearing in situ, as it came out of the car. On the left, the new ...
... whether I should take the diff out to fit the ... Rear wheel bearing - "Knocking from suspension over ... a total pig. I heated it up quite a ...
Terms matched: 3  -  Score: 1629  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=40997&start=75
Well, it's definitely a shot bearing this time - in less than 150 miles! So I've either installed it incorrectly, or there's some other problem. ...
... : Rear suspension bushes+ Diff top mounts+ diff ... Rear Wheel bearing problem, again - Part II ... them? I prefer to heat up a bearing to ...
Terms matched: 3  -  Score: 1575  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=13096
Hello all, I have been lurking for a while but I need to ask question! Having been reading through the archives , there seems to ...
... only use to remove thge diff shafts. If using ... Rear Wheel Bearings Hello all, I have been ... . Would a bit of heat help? Trying the ...
Terms matched: 3  -  Score: 1487  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=25832
Hi, Need to double check why there's movement on the wheel, but I suspect wheel bearing replacement will be called for. The manual tells me ...
... the original stub axles and diff output shafts it is ... Sprint Rear Wheel Bearing Replacement Hi, Need to ... giant" puller. Carefully heat them to ease their ...
Terms matched: 3  -  Score: 1482  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=2356
Alan Don't stop him now,he's just getting into his stride.... John
... I've decided to remove the diff now rather than wait ... Rear wheel bearing - "Knocking from suspension over ... using the inner race while heating the housing with a ...
Terms matched: 3  -  Score: 1465  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=40997&start=90
Just jacked up my S4 to start investigating a loud metallic clonking somewhere near the rear n/s wheel. At first glance nothing seems amiss so ...
... lower down than this) diff mounts / torque rods ... in the usual suspects (bearings, bushes etc) ... remove seals, and use heat. Some have reported ...
Terms matched: 3  -  Score: 1464  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=20795
Hi a relative newbie here so please forgive me if I've missed something obvious! I'm semi restoring my 71 130S +2 which I have owned ...
... undo the bolts to the diff end and take out ... Removing rear bearing carrier with Mick Miller shafts Hi ... clean the area up. Heat the hub carrier in ...
Terms matched: 3  -  Score: 1455  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=33732
did you remove the inner circlip? It really is the only thing holding the axle in I did not have great tonnage available when first ...
... out old hub shaft or diff output shaft. So ... Fitting Rear Hub bearings? did you remove the ... heater at my employer to heat the bearing to 150C ...
Terms matched: 3  -  Score: 1455  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=43871&start=15
Hi Ian Does the speedometer read like you are moving when you have it in 2nd. 3rd or 4th gears and the clutch is out? ...
... then stops. Getting really confused..assume diff is missing some teeth. ... spot if inboard of the bearing as in pic' ... slip easily, and not heat up much etc. ...
Terms matched: 3  -  Score: 1431  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=21822&start=15
So, an approach evolves. Spacer, spinner, torque, heat cycle a few times, hope Mars is in the constellation of Sagittarius, etc.
... may as well pull the diff to replace its seals ... Rear wheel bearing - "Knocking from suspension over ... , spinner, torque, heat cycle a few times ...
Terms matched: 3  -  Score: 1349  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=40997&start=45
I like the tighten, slacken one flat method. Given the amount of adjustment available, you don't want to wind up too loose. Key is that ...
... conical rollers) in the diff pinion has a substantial ... the slackening actually frees the bearings from binding. You ... brake set up dissipates the heat better. It is ...
Terms matched: 3  -  Score: 1340  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=16179&start=15
i think u have a point there john! Engine mounting on RHS is possibly at fault looks to me like there might be very little ...
... . Good day today, diff dropped out, diff ... . It went easily, bearing in mind the car ... new alloy tank having slid heat shrink over the tank ...
Terms matched: 3  -  Score: 1337  -  URL: https://lotuselan.net/forums/viewtopic.php?f=46&t=39455&start=15
IMGP0684 (1).JPG Just going to test the water as i am in process of selling house and downsizing,and what with having to do work on ...
... solid driveshaft conversion new bearings Diff rebuilt with LSD TTR ... or O/E bushes bearings track rod ends and ... minilites motordrive bucket seats new heated font screen shiney ext ...
Terms matched: 3  -  Score: 1304  -  URL: https://lotuselan.net/forums/viewtopic.php?f=2&t=39847
Corrective text grrrrr! I typed milled not milked!
... fitted now! Bigbaldybloke Your diff and chassis look nice ... - maybe do the output bearings too. I'm dreading ... now works. Made a heat shield to fit in ...
Terms matched: 3  -  Score: 1252  -  URL: https://lotuselan.net/forums/viewtopic.php?f=46&t=39455&start=30
SOLD: 1967 Lotus Elan Series 3 Fixed Head Coupe. Body off restoration just completed. Everything on this car has been totally torn down, sandblasted, powder ...
... of the very rare rear diff cooling vent. These ... , seals, gaskets & bearings. Engine block & ... and kept it in his heated garage since then. ...
Terms matched: 3  -  Score: 1251  -  URL: https://lotuselan.net/forums/viewtopic.php?f=2&t=29574
Salut I have judder on take off and only on take off. It can be minimised with judicious accelerator and clutch work and there is ...
... could the torque rod or diff mountings induce this effect ... Clutch release bearing? I'll add that I only tested ... the replacements and putting a heat shield on teh exhaust ...
Terms matched: 3  -  Score: 1251  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=23010
Hi Guys, I seem to have developed a strange noise coming from the passenger side rear. It's a rotational noise (i.e. gets faster and slower), ...
... Recently I have rebuild the diff and had the entire ... fairly sure its not wheel bearings (more of a ... will try a bit of heat on the other tonite ...
Terms matched: 3  -  Score: 1249  -  URL: https://lotuselan.net/forums/viewtopic.php?f=42&t=17879
Result Pages: 1 2 Next >>


Search took 0.150 seconds